Location Setup; Placement; Clearances - Harsco Industrial SC-1500 Owner's Manual

2.3 Location Setup

2.3.1 Placement

The boiler must be level to function properly.
1. Ensure the boiler is securely connected to the floor.
2. The boiler may be installed on a combustible floor (except carpeting) or a non-combustible surface
such as a concrete housekeeping pad.
3. Once the boiler is situated, use a bubble level to make sure the boiler is completely level.

2.3.2 Clearances

If the boiler is to be installed near combustible surfaces, the inches minimum clearances are shown in the
illustration below. Failure to provide adequate service clearances, even with non-combustible surfaces, may
present problems during routine maintenance of the boiler.
surfaces of 24" or as specified in the vent manufacturer's listed installation instructions.
installed in a space large in comparison to the boiler as described in the National Fuel Gas Code, NFPA
54/ANSI Z223.1, Latest Edition.
CSA Minimum Clearances to Combustibles
Recommended Service Clearances
* "B" Clearance depends upon exhaust vent configuration.
† "C" Space required for pipes, ducts, etc. in this area above the boiler.
** Do not put pipes, ducts, vents, etc in this space. Electrical conduit must be installed vertically so that the side
doors can be opened.
Six 9/16" holes in the base may be used for 3/8" anchor bolts.
Never install boiler on carpeting.
Type of Surface
P-K SONIC
T T T T echnical Service 1.877.728.5351 echnical Service 1.877.728.5351
echnical Service 1.877.728.5351 echnical Service 1.877.728.5351
NOTE
Maintain a clearance from the vent to combustible
Dimensions (inches)
A B
30 12*
30 12*
TM
Gas Fired Boiler
The boiler must be
C† D
24† 12**
24† 12**