Setup - Harsco Industrial MACH C1500GG Installation & Owner's Manual

3.3 S
ETUP
3.3.1 Foundation
Provide a firm, level foundation, preferably of concrete.
NOTICE! The boiler may be installed on a combustible floor, however the boiler must never be installed
on carpeting.
3.3.2 Placement
positioning this boiler, maintain positive control of it at all times. Do not attempt to move the boiler on
surfaces that are not level. Failure to heed this warning could result in personal injury or death.
Lifting the front of the boiler slightly will allow the boiler to be rolled off the shipping skid onto the concrete foundation.
Once in position, the wheel bolts may be removed allowing the wheels to recess up into the boiler. The base will sit
flat on the provided foundation. If the boiler is to be pulled out for maintenance, the wheels may be left attached.
The boiler must be level to function properly. To assist in leveling the boiler, the four (4) adjustable leg bolts (1/2"- 13
NC) must be installed. The adjustable legs are also necessary to prevent distortion of the cabinet, (twisting, etc.) in
addition to leveling.
Additionally there are three holes in the front and rear of the base that may be used for seismic anchoring.
3.3.3 Clearances
If the boiler is to be installed near combustible surfaces, the minimum clearances shown in the pictures and table
below must be maintained. Failure to provide for the service access clearances, even with non-combustible surfaces,
may cause future problems servicing the boiler. The boiler must be installed in a space large in comparison to the
boiler as described in the National Fuel Gas Code, ANSI Z223.1, latest edition.
Maintain a clearance from the vent to combustible surfaces of 18" or as specified in the vent manufacturer's listed
installation instructions.
Minimum Clearances from Adjacent Walls, Ceiling, and Obstructions (shown above &below)
A
The wheels provided with this boiler are for positioning purposes only. When
C
B
D
Page 9
MACH® Gas-Fired Boiler
D
D