10. Using additional handsets
Up to 5 handsets can be registered to one base station. Additional handsets must be
registered to the base before you can use them.
The instructions described below apply specifically to the CD3 handset. If you wish to
register another manufacturer's handset, the instructions may vary. In this case, please
refer to the instruction manual of the additional handset.
The System PIN is required to register or unregister handsets. The default PIN is 0000.
Registering an additional handset
Handset batteries must be fully charged before you start to register. Hold your handset
close to the base during the registration process. Handsets that were supplied with your
CD3 base are already preregistered.
On the base:
1. Press and hold
registration mode for 90 seconds.
On the handset:
1. Press Menu, scroll
3. Bases are displayed. If necessary, scroll
CD3 handset to and press Select.
4. Enter the system PIN and press OK.
5. The display shows
6. When registration is successful the display shows
If registration is not successful the first time, please repeat the process again in case the
base registration period ran out of time. If the base is not found after a few seconds, the
handset returns to standby. Try registering again.
If there are already 5 handsets registered to the base, registration will fail. You must de-
register a handset before you can register a new one.
Register a different make of handset to your CD3 base
DECT GAP Profile only guarantees that basic calling functions will work correctly between
different makes / types of handset and base. There is a possibility that certain features
such as Caller ID will not work correctly.
until the base emits a double beep. The base will remain in
and press Select.
is highlighted. Press Select.
to a new base you wish to register the
Using additional handsets
and you hear a