Using Additional Handsets; Registering An Additional Handset - Motorola C6 Instructions Manual

9.

Using additional handsets

You can register up to five handsets to your C6 base to extend your phone system
without having to install extension sockets for each new phone.
Each C6 handset can be registered with up to four bases. You can then select the
base you prefer to use.
If you have purchased a C6 multiple pack, all additional handsets come pre-
registered to the base.
If you have purchased an additional handset separately, you must register it to
your C6 base before it can be used.
9.1

Registering an additional handset

Note
Handset batteries must be fully charged before you start to register. Hold your
handset close to the base during the registration process. Handsets that were
supplied with your C6 base are already pre-registered.
On the base:
1. Press and hold
remain in registration mode for 90 seconds.
On the handset:
m
1. Press , scroll
d
REG BASE
2. Scroll to
3. Enter the base number (1 - 4).
The base numbers that are already in use flash. The display shows
SEARCHING....
4. When the handset finds the base signal, the display shows SEARCHING...X,
where X indicates the base identification number.
5. The display will ask for the PIN to be entered. Enter the 4 digit PIN code
(default = 0000) and press
is successful. The handset is automatically assigned an available handset
number. Use this number when making internal calls.
Note
If registration is not successful the first time, please repeat the process again in
case the base registration period ran out of time. If the base is not found after a
few seconds, the handset returns to standby. Try registering again.
If there are already 5 handsets registered to the base, the registration will fail. You
must de-register another handset before you can register a new one.
Using additional handsets
p
for 5 seconds until you hear two beeps. The base will
d
to REGISTER and press
m
and press
m
. You will hear a beep if the registration
m
.
.
31