Using Additional Handsets; Registering An Additional Handset - Motorola D502 Manual

9. Using additional handsets

You can register up to five handsets to your D5 base to extend your phone system without
having to install extension sockets for each new phone.
Each D5 handset can be registered with up to four bases. You can then select the base you
prefer to use.
If you have purchased a D5 multiple pack, all additional handsets come pre-registered to
the base.
If you have purchased an additional handset separately, you must register it to your D5
base before it can be used.
9.1

Registering an additional handset

NOTE
Handset batteries must be fully charged before you start to register. Hold your handset
close to the base during the registration process. Handsets that were supplied with your
D5 base are already pre-registered.
On the base:
p
1. Press and hold
registration mode for 90 seconds.
On the handset:
m
1. Press , scroll
d
2. Scroll to REG BASE
3. Enter the base number (1 - 4).
The base numbers that are already in use flash. Thec display shows SEARCHING....
4. When the handset finds the base signal, the display shows SEARCHING...X, where
indicates the base identification number.
5. The display will ask for the PIN to be entered. Enter the 4 digit PIN code (default =
0000) and press
is automatically assigned an available handset number. Use this number when making
internal calls.
NOTE
If registration is not successful the first time, please repeat the process again in case the
base registration period ran out of time. If the base is not found after a few seconds, the
handset returns to standby. Try registering again.
If there are already 5 handsets registered to the base, the registration will fail. You must
de-register another handset before you can register a new one.
Using additional handsets
for 3 seconds until you hear two beeps. The base will remain in
d
to REGISTER and press
m
and press
m
. You will hear a beep if the registration is successful. The handset
m
.
.
X
31