Scanning Problems - Fuji Xerox DocuPrint CM225FW User Manual

Scanning Problems

Problem
The scanner does not work.
The printer scans very slowly.
Document misfeeds or multiple feeds
occur in the ADF.
Vertical stripes appear on the output
when scanned using the ADF.
A smear appears at the same
location on the output when scanned
using the document glass.
Images are skewed.
Diagonal lines appear jagged when
scanned using the ADF.
298 Troubleshooting
Action
Make sure that you place the document to be scanned facing down on the
document glass, or facing up in the ADF.
There may not be enough available memory to hold the document you want to
scan. Try the Preview function to see if that works. Try lowering the scan
resolution rate.
Check that the Ethernet or USB cable is connected properly.
Make sure that the Ethernet or USB cable is not defective. Switch the cable with a
known good cable. If necessary, replace the cable.
Check that the scanner is configured correctly. Check the application you want to
use to make certain that the scanner job is being sent to the correct port.
Graphics are scanned more slowly than text when using the Scan to E-Mail or
Scan to Network feature.
Communication speed becomes slow in scan mode because of the large amount
of memory required to analyze and reproduce the scanned image.
Scanning images at a high resolution takes more time than scanning at a low
resolution.
Make sure that the document's paper type meets the specifications for the printer.
See also:
• "Preparing a Document" on page 127
• "Making Copies From the ADF" on page 130
Check if the document is properly loaded in the ADF.
Make sure that the document guides are adjusted properly.
Make sure that the number of document sheets do not exceed the maximum
capacity of the ADF.
Make sure that the document is not curled.
Fan the document well before loading it in the ADF.
Clean the ADF glass.
See also:
• "Cleaning the Scanner" on page 317
Clean the document glass.
See also:
• "Cleaning the Scanner" on page 317
Make sure that the document is loaded straight in the ADF or on the document
glass.
If the document uses thick media, try scanning it from the document glass.