Empty; Execfilact And Execfildeact; Flash; Icom (Intercom) - Mitel 6863i User Manual

Line Keys and Programmable Keys

Empty

Your System Administrator can set a softkey to force a blank entry on the IP phone display for a specific key by setting the
softkey to Empty. The keys are added in order (from key 1 to key 3) after any hard-coded keys have been added. If a par-
ticular key is not defined (set to None), it is ignored.

ExecFilAct and ExecFilDeact

Your System Administrator can configure which calls to forward to an executive's assistants using the Executive-Assistant
service, and can enable or disable call filtering. If call filtering is enabled, executives can activate or deactivate it using the
ExecFilAct and ExecFilDeact softkeys. When call filtering is deactivated, all calls are routed to the executive.

Flash

Your System Administrator can set a key to generate a flash event when it is pressed on the phone by setting the key to
flash. The IP phone generates flash events only when a call is connected and there is an active RTP stream (for example,
when the call is not on hold).

Icom (Intercom)

You can use the Intercom key to automatically connect with a remote extension for outgoing calls, and to answer an
incoming intercom call.
1. Press the Icom key.
2. Enter the extension number of the person you wish to intercom.
3. After a beep tone, your phone automatically connects with the remote extension and you can speak through its
speaker.
4. To cancel intercom, press
5. When you are finished speaking, hang up the phone by placing the handset back on-hook or by pressing
or the line/call appearance button for the active call. When you hang up, the remote phone also hangs up.
Your System Administrator can set specific incoming Intercom call features on the 6863i IP phone. For more information
about the incoming Intercom features and for procedures on setting these features, see
Calls" on page 36.

Paging Key

Your System Administrator can configure a Paging key on the phone that allows you to send a Real Time Transport Proto-
col (RTP) stream to pre-configured multicast address(es) without involving SIP signaling. Your administrator enters a
multicast IP address(es) and a port number for the Paging key, that when pressed, initiates an outgoing multicast RTP
session. This is called Group Paging on the IP phones. Your System Administrator can also specify group paging RTP
addresses that the phone listens for when receiving RTP streams and can specify up to 5 listening multicast addresses.
For more information about Group Paging and how it works, and to specify multicast addresses, see
page 37.
28
L1 John Smith
DND On
Tue Aug 20 2:55pm
or the Cancel key.
"Goodbye Key Cancels Incoming
"Group Paging"
6863i User Guide for Clearspan – 2895-001 – October 2014
on