Replacing The Battery - IBM Xseries 345 8670 Maintenance Manual

2. Place your fingers into the two handles on the top of the failing fan.
3. Lift the fan out of the server.
4. Orient the new fan so the LED on top of the fan is to the right of the server.
5. Push the replacement fan assembly into the server until it clicks into place.
6. Replace the cover. See "Installing the server cover and bezel" on page 71.

Replacing the battery

IBM has designed this product with your safety in mind. The lithium battery must be
handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery with
heavy-metal components, be aware of the following environmental consideration.
Batteries and accumulators that contain heavy metals must not be disposed of with
normal domestic waste. They will be taken back free of charge by the manufacturer,
distributor, or representative, to be recycled or disposed of in a proper manner.
To order replacement batteries, call your IBM reseller or IBM marketing
representative.
Note: After you replace the battery, you must reconfigure your server and reset the
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type made
by the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of.
Do not:
v Throw or immerse into water.
v Heat to more than 100° C (212° F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Complete the following steps to replace the battery:
Attention: To ensure proper system cooling, do not remove the top cover for
more than 30 minutes during this procedure.
system date and time.
1. Review the information in "Safety information" on page 121, and "Before you
begin" on page 41.
2. Follow any special handling and installation instructions supplied with the
battery.
Chapter 4. Customer replaceable units
69