Bus Fault Messages; Undetermined Problems - IBM Xseries 345 8670 Maintenance Manual

Hide thumbs Also See for Xseries 345 8670:
Table of Contents

Advertisement

Bus fault messages

Note: See "System" on page 116 to determine which components should be replaced by a field service technician.
Bus fault messages
Failure reading 12C device.
Check devices on bus 0.
Failure reading 12C device.
Check devices on bus 1.
Failure reading 12C device.
Check devices on bus 2.
Failure reading 12C device.
Check devices on bus 3.
Failure reading I2C device.
Check device on bus 4.

Undetermined problems

Use the information in this section if the diagnostic tests did not identify the failure,
the devices list is incorrect, or the system is inoperative.
Notes:
1. Damaged data in CMOS can cause undetermined problems.
2. Damaged data in BIOS code can cause undetermined problems.
Check the LEDs on all the power supplies. If the LEDs indicate the power supplies
are working correctly, complete the following steps:
1. Turn off the server.
2. Be sure the server is cabled correctly.
3. Remove or disconnect the following devices (one at a time) until you find the
Message Action
1. If installed, reseat the I2C cable between Remote Supervisor
Adapter (in PCI slot 5/J5 on the PCI riser card) and the remote
supervisor adapter connector on the PCI riser card.
2. Memory DIMMs.
3. System board.
1. Reseat the I2C cable between the operator information panel
and system board (J22).
2. Operator information panel.
3. System board.
1. Reseat the cable between system board and the power supply
(power cage assembly) (J10).
2. Power cage assembly.
3. Power supply.
4. System board.
1. Reseat the cable between the DASD backplane and connector
(J10) of system board.
2. DASD backplane.
3. System board.
v System board
failure (turn on the server and reconfigure each time):
Any external devices
Surge suppressor device (on the server)
Modem, printer, mouse, or non-IBM devices
Each adapter
Drives
Memory modules (minimum requirement = 256 MB (2 banks of 128 MB
DIMMs))
Note: Minimum operating requirements are:
a. One power supply
b. Power cage assembly.
Chapter 6. Symptom-to-FRU index
111

Advertisement

Table of Contents
loading

Table of Contents