IBM Xseries 345 8670 Maintenance Manual page 99

Note: See "System" on page 116 to determine which components should be replaced by a field service technician.
Error code/symptom
001-XXX-001
(Failed core tests)
001-250-000
(Failed system board ECC)
001-250-001
(Failed system board ECC)
005-XXX-000
(Failed video test)
011-XXX-000
(Failed COM1 serial port test)
011-XXX-001
(Failed COM2 serial port test)
014-XXX-000
(Failed parallel port test)
015-XXX-001
(USB interface not found, board damaged)
015-XXX-015
(Failed USB external loopback test)
015-XXX-198
(USB device connected during USB test)
020-XXX-000
(Failed PCI interface test)
020-XXX-001
(Failed hot-swap slot 1 PCI latch test)
020-XXX-002
(Failed Hot-swap slot 2 PCI latch test)
020-XXX-003
(Failed hot-swap slot 3 PCI latch test)
020-XXX-004
(Failed hot-swap slot 4 PCI latch test)
030-XXX-000
(Failed internal SCSI interface test)
035-XXX-099
035-XXX-S99
(Failed RAID test on PCI slot S. S =
number of failing PCI slot. Check System
Error Log before replacing a FRU.)
035-XXX-SNN
(Check System Error Log before replacing
a FRU. s = number of failing PCI slot, nn =
SCSI ID of failing fixed disk.)
FRU/action
v System board
v System board
v System board
v System board
v System board
v System board
v System board
v System board
1. Make sure the parallel port is not disabled.
2. Run the USB external loopback test again.
3. System board.
1. Remove USB devices from USB1 and USB2.
2. Run the USB external loopback test again.
3. System board.
v System board
1. PCI hot-swap latch assembly
2. System board
1. PCI hot-swap latch assembly
2. System board
1. PCI hot-swap latch assembly
2. System board
1. PCI hot-swap latch assembly
2. System board
v System board
1. No adapters were found.
2. If adapter is installed re-check connection.
1. Adapter
2. SCSI backplane
3. Cable
v Hard disk drive with SCSI ID nnon RAID adapter in PCI slot s.
Chapter 6. Symptom-to-FRU index
89