Formatting A Scsi Hard Disk Drive; Updating The Integrated System Management Firmware; Configuring The Ethernet Controller - IBM Xseries 345 8670 Maintenance Manual

3. Use the arrow keys to select a controller (channel) from the list of adapters;
4. Follow the instructions on the screen to change the settings of the selected

Formatting a SCSI hard disk drive

You can use the LSI Logic Configuration Utility program to perform a low-level
format on a SCSI hard disk drive. Complete the following steps to format a drive:
Attention:
any data before running the Low-Level Format program.
1. Select the controller channel for the drive from the list of adapters.
2. Select Device Properties.
3. Use the arrow keys to highlight the drive to format.
4. Use the arrow keys or the End key to scroll to the right.
5. Highlight the Format item; then, press Enter to start.

Updating the integrated system management firmware

To update the integrated system management (ISM) firmware for the integrated
system management processor (ISMP), you must download the image of the
Integrated System Management Firmware Update Utility program for your server
from the IBM Support Web site at http://www.ibm.com/pc/support/ on the World
Wide Web. You can then run the Integrated System Management Firmware Update
Utility program to create an Integrated System Management Firmware Update Utility
diskette that is used to update the ISM firmware. This diskette updates the ISM
firmware only and does not affect any device drivers.
Complete the following steps to update the ISMP firmware:
1. Turn off your server.
2. Insert the diskette into the diskette drive.
3. Turn on your server. If your server does not start from the diskette drive, use the
4. From the main menu, select Update System Management Firmware and
5. Follow the on-screen instructions to complete the update.

Configuring the Ethernet controller

The server comes with an integrated dual-port Ethernet controller. This controller
provides an interface for connecting to 10-Mbps, 100-Mbps, and 1000-Mbps
networks and provides full-duplex (FDX) capability, which enables simultaneous
transmission and reception of data on the Ethernet local area network (LAN).
To use the Ethernet controller, connect a Category 5 or higher unshielded
twisted-pair (UTP) cable to either of the two Ethernet ports on the rear panel of the
server.
The Ethernet connectors on the rear panel each have two LEDs. When the
Ethernet link-status LED is on, there is an active connection on the Ethernet port.
When the Ethernet transmit/receive TX/RX LED is on, there is activity between the
then, press Enter.
items; then, press Enter.
The Low-Level Format program erases all data and programs. Backup
Configuration/Setup Utility program to configure the diskette drive as a startup
device. See "Using the Configuration/Setup Utility program" on page 11. Then,
go back and start with step 1.
press Enter.
Chapter 2. Configuring your server
21