IBM Xseries 345 8670 Maintenance Manual page 113

Note: See "System" on page 116 to determine which components should be replaced by a field service technician.
Error code/symptom
289
(DIMM disabled by POST or user)
301
(Keyboard or keyboard controller error)
303
(Keyboard controller error)
602
(Invalid diskette boot record)
604
(Diskette drive error)
605
(Unlock failure)
662
(Diskette drive configuration error)
762
(Coprocessor configuration error)
962
(Parallel port error)
11XX
(System board serial port 1 or 2 error)
1301
2
(I C cable to front panel not found)
1302
2
(I C cable from system board to power on
and reset switches not found)
1303
2
(I C cable from system board to power
backplane not found)
FRU/action
1. Run the Configuration/Setup Utility program, if the DIMM was
disabled by the user.
2. Disabled DIMM, if not disabled by user.
1. Keyboard
2. System board
v System board
1. Diskette
2. Diskette drive
3. Cable
4. System board
1. Run the Configuration/Setup Utility program and diagnostics.
2. Diskette drive.
3. Drive cable.
4. System board.
1. Diskette drive
2. Drive cable
3. System board
1. Run the Configuration/Setup Utility program and diagnostics.
2. Diskette drive.
3. Drive cable.
4. System board.
1. Run the Configuration/Setup Utility program.
2. Battery.
3. Microprocessor.
1. Disconnect the external cable on the parallel port.
2. Run the Configuration/Setup Utility program.
3. System board.
1. Disconnect the external cable on the serial port.
2. Run the Configuration/Setup Utility program.
3. System board.
1. Cable
2. Front panel
3. Power switch assembly
4. System board
1. Cable
2. Power switch assembly
3. System board
1. Cable
2. Power cage assembly.
3. System board
Chapter 6. Symptom-to-FRU index
103