Secure Dishwasher - Haier DWL3025DBBB Installation Manual

Hide thumbs Also See for DWL3025DBBB:
Table of Contents

Advertisement

Available languages

Available languages

DRAINCONNECTION
7. To help minimize vibration noise, route drain
hose to avoid contact with motor, door springs,
water line, cabinet, flooring or the edge of the hole
where it passes though the cabinet. Do not remove
drain loop "N" from side of dishwasher.
8. Place the smaller drain hose clamp "N" onto the
small end of the drain hose "0".
Remove the plug
from the connector"P'.
9. Push the drain hose into the connector "P" up to
the rib "0" on the drain hose.
10. Use pliers to open clamp "N" and slide clamp
onto connector "P" belween ribs "0" on connector.
SECURE DISHWASHER
....
/1
___'_
__i i_¸]i _iW _i_
Tip Over
Hazard
Do not use dishwasher until completely installed. Do
not push down on open door.
Doing so can result in
serious injury.
1. Open dishwasher door and place towel "A"
over pump assembly and spray arm of dishwasher.
This will prevent screws from falling into pump area
when secure dishwasher to countertop.
2. Check that dishwasher is still level and centered.
3. Secure dishwasher to countertop with lwo, No.
ST4.2 x 18 Phillips-head screws "B". The dishwasher
MUST be secured to keep it from tipping when door
is opened. Do not drop screws into bottom of the
dishwasher.
4. Open door about 3 inches (7.6 cm) and check
that space belween inner door and tub is equal on
both sides. If spacing is not equal, loosen bracket
screws. If securing to sides of cabinet, replace the
plastic buttons "C".
Check that top of door does not contact screws,
brackets, or countertop. If it does, dishwasher must
be lowered and re-elevated. Remove paper towel
from dishwasher.
_
iI

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Dwl3025dbwwDwl7075dbwwDwl3025Dwl3525Dwl4035Dwl7075

Table of Contents