Bringing Up The Osd Menus; Navigating Through The Osd Menus - Barco Coronis Uniti MDMC-12133 User Manual

Hide thumbs Also See for Coronis Uniti MDMC-12133:
Table of Contents

Advertisement

To switch your display to Stand-by using the keys:
Switching off the display can be done by:
1. Push the standby key shortly for three times. After the second push, the OSD message "Power off"
appears on the display, this means the display will go in standby mode.
As a result, the display will switch to stand-by mode and the power status indicator light is orange.
In case of a power outage recovery, your display will always start-up in the power mode
it was in before the power interruption (i.e. stand-by or on). This protects your display
against inadvertent image retention problems.
4.4

Bringing up the OSD menus

How to bring up the OSD menus
The OSD menu allows you to configure different settings to make your Coronis Uniti fit your needs within
your working environment. Also, you can retrieve general information about your display and its current
configuration settings through the OSD menu.
Bringing up the OSD menus can be done by:
1. If not already done so, switch on the display as previously described.
2. Illuminate the keys as previously described.
3. While the keys are illuminated, touch the menu key.
As a result, the OSD main menu comes up in the bottom right corner of the screen. However, if no further
actions are taken within the following 90 seconds, the OSD will disappear again.
The OSD menu auto-exit function can be disabled in the OSD menu. Please refer to
"OSD menu automatic close function", page 29 for detailed instructions on how to do
this.
4.5

Navigating through the OSD menus

How to navigate through the OSD menus
Navigating through the OSD menus can be done by:
Use the left/right keys to move through the (sub)menus, change values or make selections.
To go into a submenu or confirm adjustments and selections, use the menu key.
Use the standby key to cancel adjustments or exit a (sub)menu.
Exit all OSD menus at once by touching the standby key for approximately 2 seconds.
The key icons are displayed above the keys, adapted to the function that it is used for
(menu dependent).
K5902079 CORONIS UNITI 21/04/2015
4. Daily operation
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents