Supermicro SUPERO SuperServer 1018L-MP User Manual page 54

SUPERSERVER 1018L-MP User's Manual
BIOS Recovery (JBR1)
Close pins 2 and 3 of Jumper JBR1 for
BIOS recovery. The default setting is on
pins 1 and 2 for normal operation. See
the table on the right for jumper settings.
SMB (I C) Bus to PCIe Slots
2
Jumpers JI C1 and JI
2
connect the System Management Bus
(SMB) to PCI-E and PCI slots. The de-
fault setting is set to Disabled. See the
table on the right for jumper settings.
Front Panel Audio Enable (JPAC1)
JPAC1 allows you to enable or disable
front panel audio support. The default
position is on pins 1 and 2 to enable on-
board audio connections. See the table
on the right for jumper settings
USB Wake-Up (JPUSB1)
Use the JPUSB1 jumper to enable system
"wake-up" via a USB device. This jumper
allows you to "wake-up" the system by
pressing a key on the USB keyboard or by
clicking the USB mouse of your system.
The JPUSB1 jumper is used together with
the USB Wake-Up function in the BIOS.
Enable both the jumper and the BIOS
setting to activate this function. See the
table on the right for jumper settings and
jumper connections.
Note: The default jumper setting is
"Disabled". When the "USB Wake-Up"
function is enabled, it will be active on all
USB ports.
C2 allow you to
2
5-20
BIOS Recovery
Jumper Settings
Settings Definition
Pins 1-2 Normal (Default)
Pins 2-3 Enabled
2
I C to PCIe Slots
Jumper Settings
Jumper Definition
On Enabled
Off Disabled (Default)
Front Panel Audio
Jumper Settings
Settings Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
USB Wake-Up
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled (Default)