7. Install an expansion slot cover over the vacant slot using the previously
removed screw.
8. Replace the left side panel, plug in the system power cord, and power on the
system.
Installing a RAID Controller Board
Use this procedure to install a RAID controller board.
1. Install the RAID controller board into PCI slot 4 on the system board. See
"Installing an Option Board" earlier in this chapter.
2. Cable the RAID controller board as described below (see "System Cabling"
in Appendix A):
!
Remove the end of the SCSI interface cable that is plugged into the wide
SCSI connector on the system board.
!
Reinstall the end of the SCSI interface cable just removed into the
Channel 0 connector on the RAID board.
4-20 Upgrading Your System