Parameters; Enabling Weighing Units - Adam Equipment HIGHLAND SERIES Manual

6.0 PARAMETERS
The balance has 7 parameters that can be set by the user.
FUNCTION SECTION
F1 UNT
See section 6.1
F2 EL
See section 6.2
F3 SEr
See section 6.3
F4 oFF
See section 6.4
F5 IEC
See section 6.5
F6 CA
See section 6.6
tECH
6.1 ENABLING WEIGHING
You can enable and disable the weighing units available to the user when they press
the [Mode] key as described in section 4.5 Weighing Units.
1) To set this parameter press the [Mode] key during self‐checking test when
turning on the balance.
2) After a few seconds, the display will show the first function F1 UNT.
3) Press the [Tare] key to view the current settings of each unit.
4) Pressing the [Tare] key will cycle through the other units along with their
current settings. For example, if oFF is displayed with the weighing unit Carats,
the user will not be able to use this unit while weighing.
5) Pressing the [Mode] key will change the setting of a particular unit. For
example, to enable the weighing unit Carats, change the setting to on by
pressing the [Mode] key.
14 | P a g e
DESCRIPTION
Sets the units to be used
/
g ct / Lb / oz / d / GN / OZt / dWt / MM / TL.T / TL.C / TL.t /t
/ N /g2.
Sets the backlight
EL on
EL AU
EL oFF
Sets the print parameters
Sets the auto power‐off parameter
Internal or external calibration select
Cal mass fine adjust
Technical parameters setting mode / factory setting
UNITS
: backlight always on
: backlight automatically turns on when a key is
pressed
: backlight always off
© Adam Equipment Company 2008