Configuring The Network Interface Using Epsonnet Config With Web Browser - Epson SureColor F-Series Network Manual

Configuring the Network Interface Using EpsonNet Config with Web
Browser
After you have assigned an IP address to the network interface using EpsonNet Setup,
EpsonNet Config for Windows or Mac OS, or the arp/ping command, you can configure the
network interface using EpsonNet Config with Web Browser.
Note:
A Web browser must be installed on your computer.
O
TCP/IP must be correctly set for the computer and the network interface.
O
Do not run both EpsonNet Config for Windows or Mac OS and EpsonNet Config with Web
O
Browser at the same time.
Your browser may restrict some characters you can use. For details, see your browser or
O
operating system documentation.
The following procedure shows an example of configuring the network interface on a
TCP/IP IPv4 network.
1. Turn on your printer.
2. Run EpsonNet Config using one of the following ways.
Run EpsonNet Config for Windows or Mac OS. Select the printer you want to
O
configure from the list and then click Launch Browser.
Open your browser, and then type in the IP address of the network interface directly.
O
Do not run EpsonNet Config for Windows or Mac OS.
https://IP address of network interface/
Example: https://192.168.100.201/
Note:
To check the IP address of the network interface, use EpsonNet Config. See "EpsonNet Config
O
for Windows" on page 31 for Windows users, or see "EpsonNet Config for Mac OS" on page 32
for OS X users for details.
If Windows security alert screen appears, click Continue to start EpsonNet Config with Web
O
Browser.
3. Click TCP/IP under Network on the Configuration menu, then click IPv4 Address to
display the TCP/IP IPv4 settings screen.
Note:
If you want to configure a protocol other than TCP/IP, configure the desired settings on the
Configuration - Network screen.
34
Network Software