Disconnecting Cables - Symbol PTC-960X User Manual

10. Follow the instructions for your application
program to communicate.

Disconnecting cables

Equipment required:
• A pen or small screwdriver
Always disconnect connectors by pulling them
directly away from each other. Do not pull at an
angle. Do not use a rocking or twisting motion
when pulling two connectors apart.
CAUTION! When removing a cable from the
PTC or another device, grasp the cable con-
nector head to remove the cable. Pulling on
the cable can break the wiring from the cable
connector.
1. Press the ON/OFF key on the PTC's key-
board to turn off the PTC.
2. Turn off the device the PTC is connected to.
3. Use the tip of a pen or small screwdriver to
press down the tab on the adapter cable's
connector; then pull the cable out of the
accessory connector on the PTC's left side.
4. Insert the rubber plug into the accessory
connector.
5. Disconnect the PTC's adapter cable from the
accessory or accessory cable.
6. If necessary, disconnect the accessory cable
from the other computer or accessory.
32