Table of Contents
Advertisement
•
you will connect the PTC's download
cable to the personal computer's COM1
serial port,
•
you will use the default settings for the
FLASHPC.EXE utility, and
•
you will run FLASHPC.EXE in interac-
tive mode.
If your situation differs from this, refer to the
Guide to the FLASH Utilities (TCAL or MS-DOS
Version), part number 16541-000.
Equipment required
•
A personal computer running the
MS-DOS operating system
•
A 9-pin or 25-pin PTC adapter cable (see
Appendix B
and
Appendix C
•
A 9-pin or 25-pin download cable (see
Appendix B
and
Appendix C
•
A diskette containing the FLASHPC.EXE
utility for your PTC's operating system,
either TCAL or the RAMSaver version of
MS-DOS (Optionally, FLASHPC.EXE can
be permanently stored on your PC's hard
disk drive.)
•
A diskette containing the ROM image file
(for your PTC's operating system) that
will replace the application (ARC image
file) on your PTC (Optionally, this file can
be stored on your PC's hard disk drive.)
for the correct part number
for the cable diagram)
for the correct part number
for the cable diagram)
42
Advertisement
Table of Contents
