Checking The Ptc-960X - Symbol PTC-960X User Manual

See Figure 1 on
the charger connector.
5. Plug the battery charger into a standard 110-
volt electrical outlet (220 volts outside the
U.S. and Canada).
6. Charge the battery pack for 12 hours.
7. When charging is finished, first unplug the
battery charger from the electrical outlet;
then disconnect it from the PTC.

Checking the PTC-960X

1. Press the ON/OFF key on the PTC's key-
board to turn on the PTC.
2. Look at the PTC's display.
3. What appears on the display depends on the
program your organization uses.
If the PTC is operating correctly, you should
not see or hear any of the following:
• Low battery warning
• A blank display screen
• Any warning beeps
See the "Troubleshooting" section on
if the PTC-960X is not operating correctly.
page 18 for the location of
page 49
16