Buell P3 Service Manual page 254

HOME
BEARING SELECTION
Select bearings using the identification information given for
inner and outer races and bearings. See
NOTE
If either inner or outer race show wear, measure both races to
confirm correct bearing fit.
a0131x3x
Paint Dot
Location
Figure 3-116. Factory Inner Race Paint Dot Location
(See Table 3-32 for Identification)
Table 3-31. Paint Dot Specifications
RACE OD
1.2498-1.2500 in.
(31.7449-31.7500 mm)
1.2496-1.2498 in.
(31.7398-31.7449 mm)
SERVICE WEAR LIMIT: 1.2492 in. (31.7297 mm)
Table 3-36.
Inner Race
CLASS IDENTIFICATION*
A White
B Green
a0134x3x
ID
Figure 3-117. Factory Outer Race Sizes
(See Table 3-33 for Identification)
Table 3-32. Stamp Specifications
CLASS
RACE ID
1.5646-1.5648 in.
(39.7408-39.7459 mm)
1.5648-1.5650 in.
(39.7459-39.7510 mm)
1.5650-1.5652 in.
(39.7510-39.7561 mm)
SERVICE WEAR LIMIT: 1.5672 in. (39.8069 mm)
a0133x3x
A - Roller OD cannot be
measured to required
accuracy with micrometer.
Refer to color chart in
Table 3-35.
Figure 3-118. Bearing Identification
Table 3-33. Roller Specifications
ROLLER OD (*A)
Largest
Smallest
2007 Buell P3: Engine
Outer Race
Right Crank-
case Half
*Stamped
Class No.
STAMPED
NO. IDENTIFICATION*
1 1
2 2
3 3
IDENTIFICATION*
Red
Blue
White (Grey)
Green
3-71