Buell P3 Service Manual page 256

HOME
1
1. Pinion shaft inner race
2. Flywheel (gear side)
Figure 3-120. Inner Race Location
7. See Figure 3-120. Pull inner race from pinion shaft using
WEDGE ATTACHMENT for CLAW PULLER (Part No.
HD-95637-46A) with BEARING RACE REMOVER/
INSTALLER (Part No. HD-34902B) and END CAP (Part
No. HD-34902-7). Apply heat to race to aid removal.
8. Press new inner race on pinion shaft as shown. The new
inner race must be ground by a competent machinist to
OD dimension range for the finished lapped ID of the
outer race. Refer to Table 3-35.
must meet these specifications. For necessary dimen-
sions for constructing a press-on tool see
When the tool bottoms against the flywheel, correct inner
race location is automatically established.
a0283x3x
2
The finished inner race
Figure 3-119.
Table 3-35. Pinion Inner Race Fitment
Specifications
Roundness within 0.0002 in. (0.0051 mm)
Taper within 0.0002 in. (0.0051 mm)
Surface finish 16 RMS
NOTE
Always use the smallest outer race ID measurement and the
largest OD inner race measurement when selecting bearings.
9. The following example illustrates how to determine the
required inner race OD.
a. See Table 3-36. For example purposes, suppose the
smallest outer race ID measurement is 1.5651 in.
(39.754 mm). This requires an inner race OD range
of 1.2496-1.2504 in. (31.740 - 31.760 mm).
b. Grind inner race. Measure OD at four places. Check
that specifications in Step 8 are met.
c. For example purposes, suppose the largest inner
race OD measurement after grinding is 1.2499 in.
(31.747 mm) OD.
d. With a 1.5651 in. (39.754 mm) ID outer race and a
1.2499 in. (31.747 mm) OD inner race, a blue bear-
ing is required.
NOTES
Have machinist grind inner race to center or middle of
required OD range in Table 3-36.
ing outer race undersize and gives a more easily
achieved tolerance range.
If you are unable to perform this operation, Harley-David-
son Motor Company provides a flywheel refurbishing
program as outlined in Tech Tip #38.
Always use the smallest outer race ID measurement and
the largest OD inner race measurement when selecting
bearings.
This will prevent grind-
2007 Buell P3: Engine 3-73