Washer - Buell P3 Service Manual

HOME
DISASSEMBLY
Crankcase Halves
1. Remove cylinder head. See
IMPORTANT NOTE
After removing cylinder, install plastic or rubber hose
over cylinder studs. Lifting or moving crankcase by
grasping studs will cause cylinder stud damage.
2. Remove cylinder and piston. See
PISTON.
a0484x6x
1
2
1. Screw (4)
2.

Washer (4)

3. Rear isolator
4. Dowel pin
5. Hex socket head screw (9)
6. Washer (14)
3-68 2007 Buell P3: Engine
3.5 CYLINDER HEAD.
3.6 CYLINDER AND
3
12
11
Figure 3-110. Crankcase Hardware
3. Remove oil pump. See 3.12 OIL
4. Remove gearcase components. See
COVER AND CAM GEARS.
5. Remove primary cover and primary drive/clutch compo-
nents. See 6.2 PRIMARY
6. Remove starter motor. See
7. See Figure 3-110. Remove screws and rear engine
mount bolts securing crankcase halves together.
8. Tap crankcase with plastic mallet to loosen and separate
the halves.
4
6
10
7. Bottom case t40 TORX bolt (5)
8. Hex socket head screw (1)
9. Spacer (1)
10. Crankcase set
11. Nyloc, hex locknut
12. Washer (1)
PUMP.
3.15 GEARCASE
CHAIN.
5.7 STARTER.
5
7
8
6
9