Transmission Case - Buell P3 Service Manual

HOME

TRANSMISSION CASE

GENERAL
The rear compartment of the left and right crankcase halves
form the transmission case. Servicing of transmission compo-
nents requires removing the engine and disassembling (split-
ting) the crankcase.
REMOVAL
1. Remove transmission sprocket. See
SION SPROCKET.
2. Remove engine from chassis. See
MOTORCYCLE FOR ENGINE
3. Support engine using ENGINE SUPPORT STAND (Part
No. HD-42310/HD-43646 or HD-43682).
4. Disassemble top end. See
5. Disassemble gearcase. See
AND CAM GEARS.
6. Remove primary cover. See
7. Remove clutch assembly, primary chain and engine
sprocket. See 6.4 PRIMARY
7691
1
2
1. Detent roller arm
2. Spring
3. Retention collar
4. TORX screw
Figure 6-24. Countershaft Retainer
8. See Figure 6-24. Place transmission in gear. Remove
countershaft TORX screw (4) and retention collar (3).
6-18 2007 Buell P3: Drive/Transmission
6.14 TRANSMIS-
3.3 STRIPPING
SERVICE.
3.5 CYLINDER HEAD.
3.15 GEARCASE COVER
6.2 PRIMARY CHAIN.
DRIVE/CLUTCH.
4
3
a0119x6x
1 2 3 4
11
6
10 9 8 7
1. Shifter shaft assembly
2. Locknut (2)
3. Washer (2)
4. Shifter pawl
5. Plate
6. Pin
7. Detent arm
8. Detent screw
9. Detent plate
10. Retaining ring
11. Spring
Figure 6-25. Shifter Shaft Assembly
9. See Figure 6-25. Detach spring (11) from groove in post.
10. Remove retaining ring (10) and detent plate (9). Discard
retaining ring (10). You will need to use a new retaining
ring for installation.
11. Remove starter. See 5.7
12. See Figure 6-25. Remove two locknuts (2) and washers
(3) which attach shifter shaft assembly (1) to studs at
transmission case. Remove shifter shaft assembly (1).
13. Remove detent screw (8), detent arm (7) and spring (11).
6.6
5
STARTER.