Buell P3 Service Manual page 215

HOME
Replacing Valve Guides
Valve guide replacement, if necessary, must be done before
valve seat is ground. It is the valve stem hole in valve guide
that determines seat grinding location. Valve stem-to-valve
guide clearances are listed in
or guides are worn beyond limits, install new parts.
Table 3-21. Valve Stem Clearances
and Service Wear Limits
VALVE CLEARANCE
Exhaust 0.0015-0.0033 in.
(0.0381-0.0838 mm)
Intake 0.0008-0.026 in.
(0.025-0.076 mm)
1. To remove shoulderless guides, press or tap guides
toward combustion chamber using VALVE GUIDE
REMOVER/INSTALLER (Part No. HD-34740).
2. Clean and measure valve guide bore in head.
3. Measure outer diameter of a new standard valve guide.
The guide diameter should be 0.0020-0.0033 in.
(0.0508-0.0838 mm). larger than bore in head. If it is not,
select one of the following oversizes: +0.001 in. (+0.025
mm), +0.002 in. (+0.051 mm) or +0.003 in. (+0.076 mm)
(intake and exhaust).
5692
2
1. Valve guide remover/installer (Part No. B-45524)
2. Cylinder head stand (Part No. HD-39782)
Figure 3-58. Installing Shoulderless Valve Guide
3-32 2007 Buell P3: Engine
Table 3-21. If valve stems and/
SERVICE WEAR
LIMIT
0.0040 in.
(0.1016 mm)
0.0035 in.
(0.0889 mm)
1
4. See Figure 3-58. Install shoulderless guides using
VALVE GUIDE INSTALLATION TOOL (Part No. HD-
34731) and DRIVER HANDLE (Part No. HD-34740).
Press or drive guide until the tool touches the machined
surface surrounding the guide. At this point, the correct
guide height has been reached.
5. Ream guides to final size or within 0.0010 in.
(0.0254 mm) of final size using VALVE GUIDE REAMER
(Steel, Part No. HD-39932 or Carbide, Part No. HD-
39932-CAR). Use REAMER LUBRICANT (Part No. HD-
39964) or liberal amounts of suitable cutting oil to pre-
vent reamer chatter.
NOTE
The hone is not intended to remove material.
6. Apply the proper surface finish to the valve guide bores
using the VALVE GUIDE HONE (Part No. HD-34723).
Lubricate hone with honing oil. Driving hone with an
electric drill, work for a crosshatch pattern with an angle
of approximately 60°.
5695
1
1. Valve guide brush (Part No. HD-34751)
2. Cylinder head holding fixture
(Part No. HD-39786)
Figure 3-59. Cleaning Valve Guides
7. See Figure 3-59. Thoroughly clean valve guide bores
using VALVE GUIDE BRUSH (Part No. HD-34751) and
hot soapy water.
2