Buell P3 Service Manual page 351

HOME
DISASSEMBLY
Drive out needle bearings from inside bore of main drive
gear. Do not reuse bearings after removal.
ASSEMBLY
1. See Figure 6-40. Use INNER/OUTER MAIN DRIVE
GEAR NEEDLE BEARING INSTALLATION TOOL (Part
No. HD-37842-A) for assembly. Select which end of tool
to use.
a. The end stamped 0.080 in. (2.032 mm) is for driving
the bearing into the inner end.
b. The end stamped 0.315 in. (8.001 mm) is for the
outer end bearing.
2. Assemble parts. The installation tool will automatically
bottom on the gear when the correct depth is reached.
a. Place main drive gear on a press.
b. Press in the outer bearing to a depth of 0.315-0.285
in. (8.001-7.239 mm).
c. Press in the inner bearing to a depth of 0.080 in.
(2.032 mm).
6-30 2007 Buell P3: Drive/Transmission
3554
2
1. Ram on end of press
2. Needle bearing installation tool
3. Main drive gear
Figure 6-40. Needle Bearing Installation Tool
1
3