Cateye Strada Smart CC-RD500B Online Manual page 28

The synchronized sensor is displayed on the top of the screen and pairing is completed.
• SP : Speed sensor
• ISC : Speed/cadence sensor
• CD : Cadence sensor
• HR : Heart rate sensor
• PW : Power sensor
* When pairing a sensor with a smart computer, a "C" is displayed after the sensor name.
* To pair another sensor, press MODE for 2 seconds to return to the synchronization
standby screen, and repeat the same procedure.
*If pairing is not successful and you cannot proceed to the next step, press MENU to skip
pairing. After setup is complete, retry pairing again from the menu screen.
Press MENU to proceed to the next step.
4. Enter the tire circumference.
If smart computer is not paired with a sensor capable of measuring speed, tire
circumference entry is skipped.
Enter the circumference in mm of the tire (the length of the outer circumference of the tire)
on which the sensor is installed.
(Setting range: 0100 – 3999 mm)
Determining tire circumference
* Error is displayed if values outside the setting range are entered.
* If multiple sensors capable of speed measurement have been paired, set the tire
circumference for each of the remaining sensors from the menu screen after setup.
Press MENU to proceed to the next step.
Ready for Sensor
synchronization activated
Important
(2 seconds)
Synchronization
complete
Increase number
Move to next digit