DuraLabel LabPRO User Manual page 58

4
. SYMPTOM: When using die-cuts, printing stops shortly after starting print
Possible Cause: Gap sensor has not been initialized.
Solution:
1.
Hold the FEED button while powering back ON the printer.
2.
Continue to hold FEED until the light flashes red, then release.
3.
NOTE:
Printer will dispense blank label stock as a result. (See pages 12-13 of Printer's Manual)
5
. SYMPTOM: After printing a label the LED blinks green.
Possible Cause: FEED button was pressed during printing.
Solution: Press the FEED button again to resume printing.
6
. SYMPTOM: After printing a label, printer dispenses extra label stock and LED
Possible Cause: The printer is set to print on "labels with gaps," even though
Solution:
1.
2.
3.
4.
5.
6.
(See pages 25-27 of User's Guide)
7
. SYMPTOM: The print and cut are off the mark, when using die-cut stock.
Possible Cause: Print driver is set to print on continuous-feed tape even though
Solution: Open the Printers and Faxes folder.
1.
Right-click on the Graphic Products DuraLabel
2.
Select "Printing Preferences."
3.
Click the STOCK tab.
4.
Under the "Media Settings" change "Type" to "Labels with Gaps."
5.
Click "Apply" then "OK."
6.
-56-
job and LED blinks red.
Power OFF the printer and wait 5 seconds.
blinks red.
stock being used is continuous feed.
Open the Printers and Faxes folder.
Right-click on the Graphic Products DuraLabel
Select "Printing Preferences."
Click the STOCK tab.
Under "Media Settings" change "Type" to "Continuous."
Click "Apply" then "OK."
the label stock has gaps between labels.
(See page 25 of User's Guide)
LabPRO.
®
LabPRO.
®