Table of Contents
Advertisement
5.3
Measuring your blood sugar
1
Begin the measurement by pressing the ON/OFF button.
2
The cuff inflates automatically. The unit counts upwards and
the display always shows the current cuff pressure.
3
Once the cuff has reached a sufficient pressure, the air au-
tomatically begins to be released slowly. The unit always
shows the current cuff pressure during this process. The
heartbeat symbol
As soon as the heartbeat symbol stops flashing, read your
blood pressure measured value and pulse.
For explanations and corrective actions concerning measured
values, see the next Chapter "Evaluating a blood pressure
measured value", page 28. If an error message is displayed,
read the Chapter "Troubleshooting", page 48.
4
Press the ON/OFF button. If you forget to switch off the unit,
it switches off automatically after three minutes.
Important
• If the measurement requires a higher air pressure, the unit stops releasing air
and starts pumping up again.
• You can interrupt or end the measurement at any time by pressing the
ON/OFF button. The unit releases the remaining pressure and switches off.
Beurer BGL60 mg/dL
flashes simultaneously.
27
Advertisement
Table of Contents
