Evaluating A Blood Sugar Measured Value - Beurer BGL60 Instructions For Use Manual

Note
• If the unit does not begin the measurement, do not subsequently apply more
blood. Instead, remove the test strip and end the test procedure. Start again
using a new test strip.
• If the test strip is already in the unit and you do not put any blood on it within
three minutes, the unit beeps repeatedly to prompt you to remove the test
strip and then switches off. Remove the test strip then and reinsert it into the
slot, so that the unit switches on again automatically.
• If you experience difficulties applying blood to the test strip correctly, contact
customer service.
6.3

Evaluating a blood sugar measured value

Your blood sugar measuring device can process measured values between 20 and
600 mg/dL. The warning message "Lo" is displayed for measured values below
20 mg/dL. The warning message "Hi" is displayed for a measured value above
600 mg/dL.
Note
• If you suspect that the blood sugar values are incorrect, first repeat the test
and, if necessary, perform a function test using the control solution. If you
consistently have reason to doubt the results, contact your doctor.
Beurer BGL60 mg/dL 35