Machine Sefety Regulations - SunStar KM-2070P User Manual

1
Safety instruction on this manual are defined as Danger, Warning and Notice.
If you do not keep the instructoins, physical injury on the human body and machine damage might be occurred.
Danger : This indication should be observed definitely. If not, danger could be happen during the installation,
conveyance and maintenance of machines.
Warning
: When you keep this indication, injury from the machine can be prevented.
: When you keep this indication, error on the machine can be prevented.
Notice
1-1) Machine Transportation
Danger
1-2) Machine Installation
Notice
1-3) Machine Repair
Danger
Those in charge of transporting the machine should know the safety regulations very
well. The following indications should be followed when the machine is being
transported.
ⓐ More than 2 people must transport the machine.
ⓑ To prevent accidents from occurring during transportation, wipe off the oil on the
machine well.
The machine may not work well or breakdown if installed in certain places, Install the
machine where the following qualifications agree.
ⓐ Remove the package and wrappings starting from the top. Take special notice on the
nails on the wooden boxes.
ⓑ Dust and moisture stains and rusts the machine. Install an airconditioner and clean
the machine regularly.
ⓒ Keep the machine out of the sun.
ⓓ Leave sufficient space of more than 50cm behind, and on the right and left side of
the machine for repairing.
ⓔ EXPLOSION HAZARDS
Do not operate in explosive atmospheres. To avoid explosion, do not operate this
machine in an explosive atomsphere including a place where large quantities of
aerosol spray product are being used or where oxygen is being administered unless
it has been specifically certified for such operation.
ⓕ The machine were not provided with a local lighting due to the feature of machine.
Therefore the illumination of the working area must be fulfilled by end user.
[Refer] Details for machine installation are described in 4. Machine Installation.
When the machine needs to be repaired, only the assigned troubleshooting engineer
educated at the company should take charge.
ⓐ Before cleaning or repairing the machine, turn off the main power and wait 4
minutes till the machine is completely out of power.
ⓑ Not any of the machine specifications or parts should be changed without consulting
the company.
Such changes may make the operation dangerous.
ⓒ Spare parts producted by the company should only be used for replacements.
ⓓ Put all the safety covers back on after the machine has been repaired.
5
R