SunStar KM-2070P User Manual page 12

B. Insert head support rubber A①, and head support rubber
B② to the corner of oil fan and then mount on the table.
At this time, insert rising stitch support cap ③ on the hole
of oil fan.
C. After attaching hinge① inserted to sewing bed to hinge
rubber②, put down the head of sewing machine on head
support rubber A③ and head support rubber B④on top
of the oil fan.
D. Drive Head Support Pole⑤ into table.
[ Note ]
· Drive head support pole ⑤ through into end of table firmly.
· Unless drive it into the end, when lay the head of sewing
machine, stability is not good and dangerous.
E. On condition that stood the machine as shown in the
figure, insert V belt between pulley and motor of the
machine.
②
①
⑤
①
④
④
12
②
③
[ Fig. 2 ]
③
[ Fig. 3 ]
[ Fig. 4 ]