2-24.Test Run Procedure - Sanyo SPW-C256VH Technical Data & Service Manual

2-24. Test Run Procedure
2
Turn ON the indoor
and outdoor power.
(Automatic Address setting)
Recheck the items to check
before the test run.
Check the combination (wiring)
of indoor and outdoor units.
Is system "single-type"?
YES
(1 indoor unit is connected to 1
outdoor unit)
Are multiple outdoor units used?
(See 2-26-2) How to Set the Outdoor
Unit System Address
Set the outdoor unit
system address.
(See 2-26-1, -2) How to Set Automatic Address
Set the automatic address
setting from outdoor unit.
Indicate (mark) the
combination number.
Set the indoor unit control
unit to "TEST.
Turn the power back ON
to the indoor unit.
NO
YES
(See 2-26-3, -4)
(See 2-26-3)
Can NO
operation be
started?
YES
Note: Check the indoor-
(See 2-13)
2-22
(See 2-11)
(See 2-16-1)
NO
Turn ON the indoor
and outdoor power.
(Automatic Address setting)
(See 2-25)
Refer to "Table of Self-Diagnostic
Functions" to check the system.
In addition, refer to 2-26 and
correct any items that need to be
corrected.
side drainage.
Fig. 2-22