Permanently Setting The Amount Of Water For The Cup Size; Adjusting The Grinder - Jura J90 Instructions For Use Manual

Permanently setting the
amount of water for the
cup size

Adjusting the grinder

CAUTION
It is easy to permanently adjust the amount of water for all products
to the cup size. Adjust the amount once as shown in the following
example. Every time you prepare a drink in the future, this amount
will be dispensed.
The permanent settings for adapting the amount of water to the cup
size for all speciality coffees and hot water follow this model.
Example: Proceed as follows to permanently set the amount of
water for one coffee.
Precondition: 'Please select product:'
T Place a cup under the coffee spout.
T Press and hold the
Press button'
T Release the
'Coffee'
Preparation starts and the coffee flows into the cup.
T Press any button as soon as there is sufficient coffee in the
cup.
Preparation stops.
set amount of water for one coffee is permanently stored.
'Please select product:'
E You can alter this setting at any time by repeating the above
procedure.
E The amount can be permanently adjusted to the cup size for
the products shown in the product selector too. To do this,
press and hold the Rotary Switch k until
button' appears.
E You can also permanently set the amount for all products in
programming mode (see Chapter 4 'Permanent settings in
programming mode – Product settings').
You can adjust the grinder on a continuous scale to suit the degree
of roast of your coffee.
If you adjust the consistency of grind when the grinder is not oper-
ating, the grinder adjustment switch could be damaged.
T Only adjust the consistency of grind when the grinder is run-
ning.
is displayed.
'Coffee' button until
appears.
button.
'Saved' appears briefly on the display. The
appears on the display.
2 Preparation
'Enough water?
'Enough water? Press
19