IBM System/370 Operator's Reference Manual page 179

3525 Stop Indications and Restart Procedures (cont'd)
INDICATION DISPLAYED: 3 CARD RUN IN
RECOVERY PROCEDURE:
The recovery from the previous error has not been completed.
1. •
If 3 CARD RUN IN is blinking, clear the transport and discard the
card at the print station.
If 3 CARD RUN IN is
not
blinking, clear the transport, but do
not discard the card.
2. Continue with the recovery procedure being performed when this display
If you are starting a new job, press the permanent error key twice to cancel the
recovery. CAUTION: Pressing the key cancels the recovery and recovery cannot
be accomplished.
INDICATION DISPLAYED: PERMANENT ERROR
RECOVERY PROCEDURE:
If this indicator is lighted and you did not press the permanent error key de-
liberately, press the permanent error key to turn the light off. This will ensure
that a permanent error indication posted for the last job, (or one resulting from
an unintended depression of the permanent error key) will not be associated with
the present job.
INDICATION DISPLAYED: STACKER 3
RECOVERY PROCEDURE:
The stacker 3 indicator can be on either alone or in combination with other
indications. It comes on when a card enters the reject stacker and remains on
until the start key is pressed.
If the job being processed is a data security job-that is, if it is important for the
cards or the information they contain to be kept under security-the reject stack·
er (stacker 3) must be emptied, as part of the restart procedure before the start
key is pressed, and at the end of the job. Nonsecurity error cards should be collected
for the customer engineer's examination.
INDICATION DISPLAYED: 3 CARD RUN IN, PRESS START
RECOVERY PROCEDURE:
1. Ensure that the last card stacked entered the correct stacker.
2. Remove cards from the transport manually, keeping them in sequence.
3. Repair or reproduce any damaged cards offline; reassemble cards in
correct sequence and place them with undamaged cards.
4. Place last three cards below the cards in the hopper.
5. Place remaining cards in correct stacker or stackers.
6. Press the start key.
NOTE: The permanent error key is operative during this stop.
Page 5·23