IBM System/370 Operator's Reference Manual page 152

IPL Procedure VS1
Sources: GC38-1001 VS1 Release
2
System Messages
GC38-0110 Operator's Library OSNS1 Reference
Shown below are a few sample replies to system messages received during initialization.
For complete information consult System Messages. According to your system control
program, the messages you receive may have different id's from the ones shown here.
Reply, using the id fitting your message.
To
start
IPl, dial or enter address of SYSRES volume and press lOAD button.
IEA706A SPECIFY VIRTUAL STORAGE SIZE
Press END key or reply r 0, 'u' (for default); or reply r 0, 'ddddd' where ddddd is
the number of K bytes for virtual storage.
IEA101A SPECIFY SYSTEM ANDIOR SET PARAMETERS FOR RELEASE 02.0
OSNSI
Press END key or reply r 0, 'u' to iildicate no change in parameters;
r 0, 'u, l' to indicate system should use system generation val ues for all parameters
and should print all lists;
r O:prm·: to cancel a parameter for this loading which was specified during system
IIIIneration;
r O:prm=val' to indicate the value of this parameter for this loading:
r O:prmcval,l' Ie gpecify the value for the parameter and
to
request a list of all
modules;
r O:date=yy.ddd,clock;hh.mm.ss' to reset date andlor local time;
r O:data=yy.ddd,clock;hh.mm.ss,gmt' to change date andlor GMT clock. After
YO'J
se~
the clock, press TOO ClK ENABLE switch before pressing END key.
IEA135A SPECIFY SYS1.DUMP TAPE UNIT ADDRESS OR NO
Press END key or reply r O:no' if
a
SYS1.DUMP data set will not be used; or r
O,'ddd' where ddd is the 2400/3400 series tapp
~vi~~
!c be
:!~cd fC'i -::~c ~"I"S~ .~U:'o'ir
data set.
'00
IEEBOID CHANGE PARTITIONS - REPLY YES/NO (,LlST)
(Ouotes around text are optional from here on.)
Reply r O,no to indicate partitions are not to be defined;
r a,Yes partitions are to be redefined;
r O,list only a list of partitions is wanted:
r O,yes.list partitions are to be redefined and a list is wanted.
'01 IEEl14A SPECIFY SET PARAMETERS OR U
Reply r 1,u for no set parameters;
r l,proc= for spacifying a proc;
r l,q=(.f) for formatting
th~
queue;
r l.spool=(chng,fJ for changing spool;
or any combination of these, DATE, CLOCK, and GMT are not vaiid at :his time.
'02 iFBOlOD ENTER 'IPL REASON, SUBSYSTEM ID' or 'U'
Page 4-86