IBM System/370 Operator's Reference Manual page 170

Hide thumbs Also See for System/370:
Table of Contents

Advertisement

3504/3505 Stop I ndications and Restart Procedures (cont'd)
INDICATION DISPLAYED:
THERMAl
RECOVERY PROCEDURE:
The read lamp has overheated.
1.
NPRO. (Open the hopper door and press the NPRO key.)
2.
Place last 2 cards that entered the active side of stacker 1 in correct
sequence under the cards in the hopper and close the hopper door.
3.
Press
the start key. If the read lamp has cooled enough, the thermal
light will tum off.
4.
If the thermal light remains on, allow the lamp to cool for a while,
then press the start key again. Repeat this step until the light remains
off.
5.
Press the start key.
6.
If the thermal condition is persistent, call a Customer Engineer.
NOTE: The permanent error key is operative during this stop.
INDICATION DISPLAYED:
HOPPER, JAM
RECOVERY PROCEDURE:
1.
Remove cards from hopper, repair or replace any damaged cards, and
place the removed cards in correct sequence back into the hopper and
close the hopper door.
2.
Press the start key.
NOTE: The permanent error key is operative during this stop.
INDICATION DISPLAYED:
TRANSPORT, JAM
RECOVERY PROCEDURE:
There Is
a
jam or misfeed in the transport. Two cards must be placed
back
in the
hopper.
Page 5-14
Machine without selective stacker:
1.
Examine the transport for a jam at the pre·read or read station, or for
two cards at the pre-read station.
2.
If you only recovered one card from the transport, remove the last card
that entered the active side of stacker
1.
3.
Place these cards in correct sequence under the cards in the hopper and
close the hopper door.
4.
Press the start kev.
Machine with selective stacker:
1.
Examine the transport, from the start of the pre-read station to the end
of the post-read station, for cards.
2.
Place the last 2 cards fed (that is, the two cards closest to the hopper)
in correct sequence under the cards in the hopper and close the hopper
door.
3.
Place any remaining cards in their appropriate stackers.
4.
Press the start key.
NOTE: The permanent error key is operative during this stop.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents