Table of Contents
Advertisement
8.
Enter the CAT command. if required.
to
indicate on which physi-
cal device the disk pack containing the VSAM catelog is mount-
ed.
g.
Enter the DPD command to define the page date set. DPD is
mandatory; all operands are optional.
10.
Press ENTER. The system then issues the message
DOS/VS IPL COMPLETE
in which case you can go to steps 1 1. 12. and 13. or it issues the
messages
DOS/VS IPL COMPLETE
1100A WARM START COpy OF SVA FOUND
Thera are three possible respo;1ses:
A. Enter KEEP. if you wish to keep the current copy of the SVA
(Shared Virtual Areal; in this case. steps 11. 1 2. and 13 cannot
be executed.
B. Press ENTER. This haS tbe same effact as A. above.
C. Enter REJ. if you do not wish tc keep the current copy of the
SVA; in this case
yo~
can go to steps 11. 12. and 13.
11.
if the SVA option was not specified during system generation. or
if you wish to change the size of the existing SVA. enter the SET
SVA={nK,nKI job control command.
12. If you wish to create a system directory list (SDLI. specify the
SET SDL=CREATE job control ccmmand. followed by a list of the
phase names to be included in the SDL
Ii you wish to use the IBM supplied SDL. enter the command
EXEC PROC=SDL.
13.
If you wish to create an SiJA and SDL for the VSAM modules
and include your VSAM modules in this SVA specify:
EXEC PRO('-:- IKQVPSVP..
Page 4-85
Hide quick links:
Advertisement
Table of Contents
