Table of Contents
Advertisement
3504/3505 Stop Indications and Restart Procedures
Source:
GA21-9,124-33505 Card Reader 3525 Card Punch
Subsystem Component Description
. THERMAL
STACKER·
COVER
HOPPER
OPEN
. CHECK
TRANSPORT
FORMAT
REPLACE
CARD 8
4
RESET 2
1
NPRO
JAM
MACHINE
PERMANENT
8
4
CHECK 2
ERROR
If indicators are not in a combination shown on any error display, or if an
operator recovery action is unsuccessful, treat the condition as a permanent error
and perform the procedure specified by the source program.
INDICATION DISPLAYED:
NPRO
RECOVERY PROCEDURE:
Recover is likely.
1.
NPRO. (Open the hopper door and press the NPRO key.)
2.
Place the last 2 cards that entered the active side of stacker 1 in correct
sequence under the cards in the hopper and close the hopper door.
3.
Press the start key.
NOTE: The permanent error key is operative during this stop.
INDICATION DISPLAYED:
NPRO, MACHINE CHECK
RECOVERY PROCEDURE:
Recovery is possible. If desired, perform the procedure specified for the NPRO
indication two or three times.
Perform the NPRO indication procedure, or if that procedure fails repeatedly:
1.
If the reader has a log-out key, press it and write down the digits on
each row of the backlighted panel.
2.
If the reader has no log-out key, record the error information from the
reader log display at the system console.
3.
When you report the problem to the CE, also report the error informa-
tion you recorded.
NOTE: The permanent error key is operative during this stop.
Page 5-11
Hide quick links:
Advertisement
Table of Contents
