IBM System/370 Operator's Reference Manual page 154

IPL Procedure VS2
Sources:
GC38-1002
VS2 Release
1.6
System Messages
GC38-0210 Operator's Library OSNS2 Reference
Shown below are a few sample replies to system messages received during initialization.
For complete information consult System Messages. According to your system control
program, the messages you receive may show different id's from the ones shown here.
Reply, using the id appropriate to your message.
To start IPL, dial or enter address of SYSRES volume and press LOAD key.
IEAIOIA SPECIFY SYSTEM PARAMETERS FOR RELEASE 01.6 VS2
Press END key or reply r O,u for default (the system will use the default system
parameters in SYS1.PARMLlB); or
r O,u, L default and a list of system parameters;
r O,parm;, to cancel the parameter for this IPL which was specified during system
generation;
r O,parm;yal,L to specify the value for the parameter and request a list of system
parameters.
IEA332A SPECIFY DUMP OR CANCEL
Press END key to cancel or reply r O,DUMP parm (if function is used).
"IEEI14A DATE;73.323,CLOCK;11.08.52
'00
IEE114A DATE;73.323,CLOCK;16.08.52.GMT REPLY WITH SET PARM OR U
Reply r O,u if date and time are correct and there are no set parameters;
r O,proc'" (specify proc or r
O,aut~nnn
(to overridi! auto commands .. n for no, y for
yes)
0'
r O,q;(252,f) to format the queue; or any combination of these. Do not press
the TOO CLK ENABLE switch.
Reply r O,data;yy.ddd,clock=hh.mm.ss,gmt to change date and/or GMT clock.
After yoo set clock, depress TOO CLK ENABLE switch before pressing
END key.
"01 IFBOIOD ENTER 'IPL REASON, SUBSYSTEM 10' OR 'U'
Reply r I,u to continue operation with default values; or
r I,rr,ss where rr is the ROE IPL Reason Code and ss is the Subsystem 10 code.
IPL Reason Code Subsystem 10 Code
NM Normal 00 Null
IE IBM hardware/programming problem, 10 Processor
CE/SE not required 20 Direct Access
ME Media 30 Other
UN Unknown 40 Tape
OP Operational
50
Card/Print
UP User Program 60 MICR/OCR
EN Environmental 70 Teleprocessing
CE CEISE has the sy.l.m 80
G r aph
j c.!DisplayiA'l':!iO
90 IBM System Control Program
SOURCE: GC28·0638
91
Programming Product
"02 IEE357A REPLY WITH SMF VALUES OR U
Reply r 2,u (for default) or r 2,keyword;value where
~eyword
is an SMF parameter
specified by your system programmer.
Page
4-88