Table of Contents
Advertisement
3504/3505 Stop Indications and Restart Procedures (cant'd)
INDICATION DISPLAYED:
NPRO, CHECK CARD
RECOVERY PROCEDURE:
1.
NPRO. (Open the hopper door and press the NPRO key.)
2.
Remove the last two cards that entered the active side of stacker 1. The first
card stacked is in error; check this card for more than one punch in row posi·
tions
1
through
7
in each column and for poor punch registration.
(If
necessary .. replace the card with a card punched correctly offline.) Place the
two cards in correct sequence under the cards in the hopper and close the
hopper door.
3.
Press the start key.
Note: The permanent error key is operative during this stop.
INDICATION DISPLAYED:
NPRO, HOPPER, REPLACE
1
RECOVERY PROCEDURE:
Recovery is likely.
1.
NPRO. (Open the hopper door and press the NPRO key.)
2.
Place the last card that entered the active side of stacker 1 back into
the hopper, then close the hopper door.
3.
P,.ss the start key and the end·of·file key.
NOTE: The permanent error key is operative during this stop.
INDICATION DISPLAYED:
NPRO, HOPPER, REPLACE 1, MACHINE CHECK
RECOVERY PROCEDURE:
Recovery is possible. If desired, perform the NPRO and REPLACE
1
procedure
two or three times. If you do not perform that procedure, or if that procedure
fails repeatedly:
1.
If the reader has a log·out key, press it and ·write down the digits on
each row of the backlighted panel.
2.
I f the reader has no log·out key, record the error inform at ion from the
r~ader
log display at the system console.
3.
When you report the problem to the CE, also report the error informa·
tion you recorded.
Note: The permanent error key is operative during this stop.
INDICATION DISPLAYED:
NPRO, CHECK CARD, REPLACE
1
RECOVERY PROCEDURE:
Page 5·12
1.
Remove the cards from the hopper and examine the bottom card for
anything that may have caused the misfeed (a burred edge, for ex·
ample). Reproduce this card, if necessary.
2.
Press NPRO key.
3.
Place the last card that entered the active side of stacker 1 in correct
sequence with the card from
1
above and place them under the cards
removed from the hopper.
4.
Put the cards back into the hopper and close the hopper door.
5.
Press the start key.
Hide quick links:
Advertisement
Table of Contents
