IBM System/370 Operator's Reference Manual page 178

3525 Stop Indications and Restart Procedures (cont'd)
INDICATION DISPLAYED: NPRO, CHECK CARD
RECOVERY PROCEDURE:
1.
Press the stop key: the J.card run-in light will
come on.
2.
Empty stacker
1.
3. .
NPRO. (While holding cards in hopper away from bottom of hopper,
run cards out of transport by holding the NPRO key down.)
4. If there are cards remaining in the hopper and only two cards NPRO to
stacker 1, press permanent error key twice to cause two card run-in.
5. Remove and examine the cards that ran into stacker 1. Repair, or
replace with a manually-reproduced card, any damaged cards.
6.
Place all these run-out cards under the deck in the hopper, maintaining
correct card sequence.
7.
Press
the start key.
NOTE: The permanent error key is operative during this stop. If indicatioo
is continuous, check to be sure that upper read head is latched.
INDICATION DISPLAYED: FORMAT RESET
RECOVERY PROCEDURE:
Indicates that a read column eliminate format has been reset by an unformatted
read only command or by an unformatted read, feed, and select stacker com-
mand. If this error occurs within a job, and if the operator has no other informa-
tion from the programmer, the operator should press the stop key, permanent error
key, then the
stan
key to make the device ready. If this error occurs within a job and
the programmer has provided operator instructions, the operator should follow these
instructions. If this error occurs at job initiation, the operator should NPRO Oift the
cards off the bottom of the hopper and press the NPRO key), load the last two cards
&r.ter
ir'll
.1iK;l..",
1
iJa<;~
under the carcis in tile hopper, and press the start key.
NOTE: The permanent error key is operative during this stop
INDICATION DISPLAYED: OFFLINE
RECOVERY PROCEDURE:
Indicates that the 3535 is disconnected from the
system
functionally.
To place the 3525 online:
Page 5-22
1. Set the ONLINE/OFFLINE switch to its ONLINE setting.
NOTE: The ONLINE/OFFLINE switch is located at the attachment. If the
3525 is attached to the 3505, the switch is under the 3505 front cover.