IBM System/370 Operator's Reference Manual page 174

3525 Stop Indications and Restart Procedures (cont'd)
INDICATION DISPLAYED: STACKER
RECOVERY PROCEDURE:
1. Empty the full stacker.
2. Press the start key.
NOTE: If the stacker light is
on
and neither stacker
1
nor stacker
2
is full,
check for the reject stacker being full.
NOTE: The permanent error key is operative during this stop.
INDICATION DISPLAYED: COVER OPEN
RECOVERY PROCEDURE:
1.
Close any cover that is open.
2. Press the start key.
NOTE: The permanent error key is operative during this stop.
INDICATIO~
DISPLAYED: FEED OPEN
RECOVERY PROCEDURE:
1.
Make sure upper read head is latched.
2.
Close and latch the feed mechanism.
3. Press tile starr key.
NOTE: The permanent error key is operative during this stop.
INDICATION DISPLAYED: JAM, 3 CARD RUN IN
RECOVERY PROCEDURE:
Page 5·18
1.
Remove cards from the transport manually, keeping them in sequence.
2. Repair or reproduce any damaged cards offline; reassemble cards in
correct sequence and place them with undamaged cards.
3. •
If
3
CARD RUN IN is blinking, place the last two cards below the
cards in the hopper and discard the preceding card.
If
3
CARD RUN IN is
not
blinking, place last three cares below
cards in hopper.
4. Place remaining cards
in COHee!
stacker
or
Slackers.
5.
Press the start key.
NOTE: The permanent error k~y is operative during this stop.