Table of Contents
Advertisement
3504/3505 Stop Indications and Restart Procedures (cont'd)
INDICATION DISPLAYED:
JAM, TRANSPORT, CHECK CARD, HOPPER
REPLACE 1
RECOVERY PROCEDURE:
1.
Locate and remove the card from the transport.
2.
Check the card for damaged edges.
3.
Repair
or
reproduce the card, if necessary.
4.
Place the card in the hopper.
5.
Press the start key and end·of·file key.
NOTE: The permanent error key is operative during this stop.
INDICATION DISPLAYED:
FORMAT RESET
RECOVERY PROCEDURE:
Indicates that an optical mark read or read column eliminate format has been
reset by an unformatted read only command or by an unformatted read, feed and
select stacker command. If this error occurs within a job, and if the operator has
no other information from the programmer, the operator should press the stop
key, permanent error key, then the start key to make the device ready. If this
error occurs within a job and the programmer has provided operator instructions,
the operator should follow these instructions. If this error occurs at job initiation,
the operator should NPRO, place
the
last two cards entering the active side of
stacker 1 in correct sequence under the cards in the hopper, close the hopper
door, and press the start key.
INDICATION DISPLAYED:
NPRO. PERMANENT ERROR
RECOVERY PROCEDURE:
This is
a
device permanent error - command reject.
1.
Perform the error recovery specified by the source program for this type
of error.
INDICATION
t
DISPLAYED:
JAM, TRANSPORT, PERMANENT ERROR
RECOVERY PROCEDURE:
This is a device permanent error.
1.
If the reader has a log-out key, press it and write down the digits from
l'aCh rO\lll of the backlighted panel.
2.
I f the reader has no log·out key, record the error information from the
reader log display at the system console.
3.
When you report the problem to the CE, also report the error informa·
tion you recorded.
INDICATION DISPLAYED:
JAM, MACHINE CHECK, PERMANENT ERROR
RECOVERY PROCEDURE:
Consider this a permanent error condition and perform the procedure specified by
the source program. During this procedure the NPRO key should be pressed with
the hopper door open to run cards out of the unit.
Page 5·16
Hide quick links:
Advertisement
Table of Contents
