Table of Contents
Advertisement
3525 Stop Indications and Restart Procedures (cont'd)
INDICATION DISPLAYED:
MACHINE CHECK, PRESS START
RECOVERY PROCEDURE:
1.
Press the start key.
NOTE: The permanent error key is operative during this stop.
INDICATION DISPLAYED:
NPRO,
3
CARD RUN IN
RECOVERY PROCEDURE:
1.
Remove cards from hopper and examine throat area.
If partially·fed card is stuck in throat, remove it, repair or replace
it, and put it
on
bottom of stack removed from hopper.
b.
Remove any dust
or
pieces of paper from throat area.
2.
Empty stacker 1.
3.
NPRO (press the NPRO key.)
4.
•
If
3
CARD RUN IN is blinking, discard first card that entered
stacker 1; place any other stacker 1 cards in hopper.
If
3
CARD RUN IN is not blinking, place all cards that entered
stacker 1 in hopper.
5.
Place cards removed from hopper back into hopper.
6.
Press
the
start key.
NOTE:
The permanent error key is operative during this stop. During
NPRO, three cards should enter stacker 1 unless one card was
stuck in throat; if card was stuck in throat, two cards should enter
stacker 1.
INDICATION DISPLAYED:
JAM, PERMANENT ERROR
RECOVERY PROCEDURE:
1.
Manually remove all cards from the card transport.
2.
Perform the procedure specified by the source program
INDICATION DISPLAYED:
JAM, MACHINE CHECK, PERMANENT ERROR
RECOVERY PROCEDURE:
1.
Manually remove all cards from the card transport.
2.
Perform the procedure specified by the source program.
INDICATION DISPLAYED:
JAM, PRESS START, MISSElECT
RECOVERY PROCEDURE:
A pu nch error occurred and the error card failed to enter stacker
3.
Page 5·20
1.
Examine the last cards to enter stackers
1
and
2
for a card containing a
punch error. Place this card in stacker
3.
2.
Press the start key.
NOTE: The permanent error key is operative during this stop.
Hide quick links:
Advertisement
Table of Contents
