Status Leds - B&R Industries MAPPC900-ENG User Manual

Technical data • Complete system

2.4.11 Status LEDs

The Status LEDs are located on the right side of the Panel PC when viewed from the front.
The following timing is used for the LED status indicators:
Block size: 250 ms
Repeat interval: 500 ms, 2 boxes thus represent one interval
LED Color Status
Power Green On
Blinking
Red On
Blinking
Red / green Blinking
Yellow On
HDD Yellow On
Link Yellow On
Blinking
Run Green Blinking
Green On
Red On
48
Description
Supply voltage OK
Device booted, battery status "BAD"
Information:
For more information, see "Battery" on page 50.
System in standby mode (S5: Soft-off mode or S4: Hibernation
mode suspend-to-disk)
MTCX running, battery status "BAD". System in standby mode
(S5: Soft-off mode or S4: Hibernation mode suspend-to-disk).
Faulty or incomplete BIOS, MTCX or I/O FPGA update, battery
status OK, supply voltage OK
Faulty or incomplete BIOS, MTCX or I/O FPGA update, battery
status OK, standby mode (S5: Soft-off mode or S4: Hiberna-
tion mode suspend-to-disk)
Faulty or incomplete BIOS, MTCX or I/O FPGA update, battery
status BAD, supply voltage OK
Faulty or incomplete BIOS, MTCX or I/O FPGA update, battery
status BAD, standby mode (S5: Soft-off mode or S4: Hiberna-
tion mode suspend-to-disk)
Information:
An update must be performed again.
Supply voltage not OK, system operating from UPS
Indicates drive access (HDD, CFast)
Indicates an active SDL connection on the male panel connec-
tor
Indicates that an active SDL connection has been interrupted
by a loss of power to the display unit
Information:
Check the supply voltage / power connector of the
connected display unit.
Automation Runtime booting
Controlled by Automation Runtime (ARemb and ARwin)
Application running
Controlled by Automation Runtime (ARemb and ARwin)
Application in service mode
Controlled by Automation Runtime (ARemb and ARwin)
Table 40: Data - LED status indicators
Power LED
HDD LED
Link LED
RUN LED
LED status indicator
Panel PC 900 User's Manual V1.05