Table of Contents
Advertisement
2.4.5 Monitor/Panel interface
The following is an overview of the video signals available on the monitor/panel output.
For details, see the technical data for the CPU board being used.
CPU board
5PC901.TS77-00
5PC901.TS77-01
5PC901.TS77-02
5PC901.TS77-03
5PC901.TS77-04
5PC901.TS77-05
5PC901.TS77-06
5PC901.TS77-07
5PC901.TS77-08
5PC901.TS77-09
5PC901.TS77-10
Information:
The hardware and graphics drivers of approved operating systems support the hot-plugging of dis-
play devices to the monitor/panel interface for service purposes. The male monitor/panel connector
is specified for 100 connection cycles.
Information:
If a display device with a touch screen is connected to the monitor/panel interface and then discon-
nected again during operation (hot-plugging), it may be necessary to recalibrate the touch screen.
Information:
The RGB interface uses an analog signal; the line length depends on the resolution and prevailing
environmental conditions. This interface is therefore only recommended for service purposes.
2.4.5.1 USB transfer rates in SDL and DVI modes
Information:
In SDL mode, the USB transfer rate is limited to USB 1.1.
In DVI mode, the maximum USB transfer rate is determined by the USB interface and USB hub on the
display device.
2.4.5.2 Pinout
Pin Assignment
Description
1 TMDS data 2-
DVI lane 2 (negative)
2 TMDS data 2+
DVI lane 2 (positive)
3 TMDS data 2/4
Shield for data pair 2 and 4
SHIELD
4
SDL-
SDL lane (negative)
5 SDL+
SDL lane (positive)
6
DDC-based control signal
DDC clock
(clock)
7
DDC-based control signal
DDC data
(data)
8 N.C.
Not connected
9 TMDS data 1-
DVI lane 1 (negative)
10
DVI lane 1 (negative) HDMI
TMDS DATA 1+
clock (positive)
TMDS DATA 1/
Shield for data pair 1 and
11
XUSB0 SHIELD
USB0
12 XUSB0-
USB lane 0 (negative)
13
XUSB0+
USB lane 0 (positive)
Panel PC 900 User's Manual V1.05
Monitor/Panel interface - RGB / SDL (Smart Display Link) / DVI
Video signals for all system unit variants
RGB, DVI, SDL
RGB, DVI, SDL
RGB, DVI, SDL
RGB, DVI, SDL
RGB, DVI, SDL
RGB, DVI, SDL
RGB, DVI, SDL
RGB, DVI, SDL
RGB, DVI, SDL
RGB, DVI, SDL
RGB, DVI, SDL
Table 31: Monitor/Panel interface - RGB, DVI, SDL
Pin Assignment
16 HPD
17 TMDS data 0-
18 TMDS data 0+
TMDS Data 0/
19
XUSB1 SHIELD
20 XUSB1-
21 XUSB1+
TMDS clock
22
shield
23 TMDS clock+
24 TMDS clock -
C1 ANALOG RED
ANALOG
C2
GREEN
C3 ANALOG BLUE Analog blue
ANALOG
C4
HORZ SYNC
Table 32: DVI interface - Pinout
Technical data • Complete system
Description
Hot plug detect
DVI lane 0 (negative)
DVI lane 0 (positive)
Shield for data pair 0 and
USB1
USB lane 1 (negative)
USB lane 1 (positive)
Shield for clock pair
DVI clock (positive)
DVI clock (negative)
Analog red
Analog green
Analog horizontal synchro-
nization
DVI 24-pin, female
1 2 3 4
5
6
7 8
c1
c2
9 10 11 12
13
14 15 16
c3
c4
17 18 19 20
21
22 23 24
c5
43
Advertisement
Table of Contents
