Table of Contents
Advertisement
Installation • Installation
1.11 Installing PCI / PCIe cards
1. Disconnect the power supply to the B&R industrial PC (unplug the power cable!). Isolate from all potential
sources of electrical power!
2. Touch the housing or ground connection in order to discharge any electrostatic charge from your body.
3. Remove the Panel PC from the control cabinet. To do so, follow the steps in section "Installation Panel PC
900" on page 132 in reverse order.
4. Place the Panel PC on a clean, flat surface.
5. Remove the Torx screws (T10) indicated in the following image. Slide the cover plate forward to remove it.
6. Remove the PCI slot cover from the bus unit. This is done by first removing the marked Torx screws (T10)
and then removing the cover.
150
Figure 82: Removing the Torx screws and side cover
Figure 83: Removing the Torx screws and slot cover
Panel PC 900 User's Manual V1.05
Advertisement
Table of Contents
