Table of Contents
Advertisement
1.6 Installing the interface option
Information:
Please note that not every interface option can be installed in interface slots 1 and 2. For more infor-
mation, see "IF option 1 slot" on page 53 and "IF option 2 slot" on page 53.
1. Disconnect the power supply to the B&R industrial PC (unplug the power cable!). Isolate from all potential
sources of electrical power!
2. Touch the housing or ground connection in order to discharge any electrostatic charge from your body.
Information:
If a bus unit is mounted on the Panel PC it must first be removed.
3. Remove the Torx screws (T10) indicated by ➀ in the following image. The Torx screws indicated by ➁ only
need to be removed if an IF option is already mounted.
4. Lift the cover plate up and away to remove it.
Panel PC 900 User's Manual V1.05
Figure 67: Removing the Torx screws from cover plate
Figure 68: Removing the cover plate
Installation • Installation
141
Advertisement
Table of Contents
